Getting started : Contents of the package : Setting up the handset for use
Setting up the handset for use
The display is protected by a plastic film.    Please remove the protective film!
Inserting the battery
 
Only use the specified battery, as this could otherwise result in significant health risks and personal injury. For example,   the outer casing of the battery could be destroyed or the battery could explode. The device could also malfunction or be damaged as a result of using batteries that are not of the recommended type.
*Insert battery with the contact side pointing down .
*Press the battery down until it clicks into place .
*Orientate the battery cover with the side tabs fitting into the slots on the inside of the casing .
*Press the cover until it clicks into place.
Re-opening the battery cover
*Remove the belt clip (if attached).
*Place your fingernail in the notch underneath the battery cover and pull the battery cover up .
*To change the battery, place your fingernail in the recess in the housing and pull the battery up .
Charge the battery
*Charge the battery fully prior to first use in the charging cradle or using a standard USB mains adapter.
The battery is fully charged when the power icon disappears from the display.
 
The battery may heat up during charging. This is not dangerous.
After a time, the charge capacity of the battery will decrease for technical reasons.
Attaching the belt clip
The handset has notches on each side for attaching the belt clip.
*Attaching the belt clip:    Press the belt clip onto the back of the handset so that the tabs on the belt clip click into place in the notches.
*Removing the belt clip:    Press the centre of the belt clip firmly with your right thumb.    Push the nail of your left thumb up between the clip and the casing.    Slide the clip upwards to remove.
Changing the display language
You can change the display language, if the telephone has been set to an incomprehensible language.
*Press the centre of the control key .
*Press the keys and slowly and successively . . . the language settings display appears, the set language (e. g. English) is highlighted ( = selected).
*To select a different language:    Press the control key until the desired language is highlighted on the display, e. g. Francais    press the key on the right directly underneath the display to activate the language.
*To revert to idle status:    Press and hold the End call key
Registering a handset
A handset can be registered to up to four base stations. The registration process depends on the base station.
 
Registration must be initiated on the base station and on the handset.
Both must be carried out within 60 secs.
On the base station
*Press and hold the Registration/Paging key on the base station (approx. 3 sec.).
On the handset
*    . . . use  to select  Settings    OK    Registration    OK   Register Handset    OK    . . . use to select base station (if the handset is already registered to four base stations)    OK  . . . an available base station is sought    . . . enter system-PIN (default setting: 0000)    OK
Once registration is complete, the handset returns to idle status. The internal number of the handset appears in the display, e. g. INT 1. If not, repeat the procedure.