Setting up the handset for use
The display is protected by a plastic film. Please remove the protective film!
Inserting the batteries and closing the battery cover
| Use only rechargeable batteries recommended by Gigaset Communications GmbH ( Technical data) , as this could otherwise result in significant health risks and personal injury. For example, the outer casing of the batteries could be destroyed or the batteries could explode. The phone could also malfunction or be damaged as a result of using batteries that are not of the recommended type. |
Insert the batteries with the polarity in the right direction (for correct +/- direction, see diagram).
Hold the battery cover at a slight angle and insert the bottom into the casing first
.
Then press the cover
until it clicks into place.
Insert the locking disc as shown (at an angle of approx. 20°)
. Pay attention to the arrow markings.
Turn locking disc clockwise to the end stop
. The locking disc is closed once the markings on the disc are aligned with those on the cover
.
To open the battery cover, for example to change the batteries:
Turn the locking disc anti-clockwise to the end stop
(approx. 20°) and remove
.
Place your fingernail in the notch on the side between the cover and the casing
and remove the cover
.
Charging the batteries
The batteries are supplied partially charged. Please charge completely before use. (The batteries are fully charged when the power icon
disappears from the display.)
Charge the handset in the charging cradle for
7.5 hours.
|  The handset may only be placed in the designated base/charging cradle. The battery may heat up during charging. This is not dangerous. After a time, the charge capacity of the battery will decrease for technical reasons. |
