Getting started : Setting up the handset for use
Setting up the handset for use
The display is protected by a plastic film.    Please remove the protective film!
Inserting the batteries
 
Only use rechargeable batteries, as this could otherwise result in significant health risks and personal injury. For example, the outer casing of the batteries could be destroyed or the batteries could explode. The telephone could also malfunction or be damaged as a result of using batteries that are not of the recommended type.
*Insert the batteries (for correct +/- direction, see diagram).
*Fit the battery cover from the top.
*Press the cover until it clicks into place.
To re-open the battery cover:
*Insert a fingernail behind the notch at the top of the cover and slide it downwards.
Charging the batteries
*Charge the batteries fully prior to first use in the charging cradle or using a standard USB mains adapter.
The batteries are fully charged when the power icon disappears from the display.
 
The handset may only be placed in the designated charging cradle.
The battery may heat up during charging. This is not dangerous.
After a time, the charge capacity of the battery will decrease for technical reasons.
Attaching the belt clip
The handset has notches on each side for attaching the belt clip.
*Attaching the belt clip:    Press the belt clip onto the back of the handset so that the tabs on the belt clip click into place in the notches.
*Removing the belt clip:    Press the centre of the belt clip firmly with your right thumb.    Push the nail of your left thumb up between the clip and the casing.    Slide the clip upwards to remove.
Changing the display language
You can change the display language, if the telephone has been set to an incomprehensible language.
*Press middle of the control key .
*Press the keys and slowly and successively . . . the language settings display appears, the set language (e.g. English) is highlighted ( = selected).  
*Select different language:    Press the control key until the desired language is highlighted on the display, e.g. Francais    press the key on the right directly underneath the display to activate the language. 
*To revert to idle status:    Press and hold the End call key
Registering the handset
A handset can be registered to up to four base stations. The registration process depends on the base station.
 
Registration must be initiated on the base station and on the handset.
Both must be carried out within 60 secs.
On the handset
*    . . . use   to select Settings    OK    Registration    OK   Register Handset    OK    . . . use to select the base station (if the handset is already registered to four base stations)    OK  . . . a base station that is ready for registration is sought    . . . enter the system PIN    OK
Once registration is complete, the handset returns to idle status. The handset name is shown in the display. If not, repeat the procedure.